DESCRIPTION When the
dynamic radar cruise control system is turned on using the cruise
control main switch (ON-OFF button), the cruise control indicator
(vehicle-to-vehicle distance control mode) illuminates. The ECM uses
this and other indicators to indicate the control condition (presence or
absence of a preceding vehicle, vehicle-to-vehicle distance, and set
vehicle speed) and fail-safe state via CAN communication. CAUTION / NOTICE / HINT
NOTICE:
- Before replacing the ECM, refer to Registration.
Click here 
- When replacing the combination meter assembly, always replace it with a
new one. If a combination meter assembly which was installed to another
vehicle is used, the information stored in it will not match the
information from the vehicle and a DTC may be stored.
PROCEDURE |
1. | PERFORM ACTIVE TEST USING TECHSTREAM (METER DISPLAY 1) |
(a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON.
(c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Combination Meter / Active Test.
(e) Perform the Active Test according to the display on the Techstream.
Body Electrical > Combination Meter > Active Test |
Tester Display | Measurement Item |
Control Range | Diagnostic Note | |
Meter Display 1 | Multi-information display |
OFF or All | - |
|
Result | Proceed to | |
The multi-information display in the combination meter assembly turns on or off according to the operation of the Active Test. |
A | | The
multi-information display in the combination meter assembly does not
turn on or off according to the operation of the Active Test. |
B |
| B |
 | GO TO METER / GAUGE SYSTEM |
|
A |
 | |
| 2. |
READ VALUE USING TECHSTREAM (CRUISE READY MAIN-CPU, CRUISE READY SUB-CPU, CRUISE INDICATOR) |
(a) Enter the following menus: Powertrain / Radar Cruise1 / Data List.
(b) Read the Data List according to the display on the Techstream. Powertrain > Radar Cruise1 > Data List |
Tester Display | Measurement Item |
Range | Normal Condition |
Diagnostic Note | |
Cruise Ready Main-CPU | Cruise control system standby condition |
ON or OFF | Each time cruise control main switch (ON-OFF button) is pushed, ON or OFF changes |
- | | Cruise Ready Sub-CPU |
Cruise control system standby condition |
ON or OFF | Each time cruise control main switch (ON-OFF button) is pushed, ON or OFF changes |
- | | Cruise Indicator |
Cruise control indicator status |
ON or OFF | ON: Cruise control indicator illuminates
OFF: Cruise control indicator turns off |
- | |
Result | Proceed to | |
The
cruise control indicator illuminates and turns off according to the
operation of the cruise control main switch (ON-OFF button). |
A | | The
cruise control indicator does not illuminate but the Data List item
Cruise Indicator changes according to the operation of the cruise
control main switch (ON-OFF button). |
B | | The
cruise control indicator does not illuminate and the Data List item
Cruise Indicator does not change according to the operation of the
cruise control main switch (ON-OFF button). |
C |
| A |
| PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
| B |
| REPLACE COMBINATION METER ASSEMBLY |
| C |
| REPLACE ECM | | 
