CAUTION / NOTICE / HINT
HINT:
- Use the following procedure listed to troubleshoot the touch select 2-4 and high-low system.
- *: Use the Techstream.
PROCEDURE |
1. | VEHICLE BROUGHT TO WORKSHOP |
|
NEXT |
 | |
| 2. |
CUSTOMER PROBLEM ANALYSIS |
|
NEXT | |
| |
| 3. |
INSPECT BATTERY VOLTAGE | Standard Voltage:
11 to 14 V If the voltage is below 11 V, recharge or replace the battery before proceeding.
|
NEXT | |
| |
| 4. |
CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
(a) Use the Techstream to check if the CAN communication system is functioning normally.
Click here 
HINT: The ECU of this system is connected to the CAN communication system.
Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.
|
Result | Proceed to | |
CAN DTCs are not output |
A | | CAN DTCs are output |
B |
|
A | |
| |
(a) Check for DTCs.
Click here (1) Record the DTCs.
(b) Clear the DTCs. Click here
(c) Recheck for DTCs. Click here
(1) Simulate the malfunction condition and check if the DTCs are output again.
|
Result | Proceed to | |
DTCs are not output | A | |
DTCs are output | B |
| B |
 | GO TO STEP 10 |
|
A | |
| |
| 6. |
PROBLEM SYMPTOMS TABLE | (a) Refer to Problem Symptoms Table.
|
Result | Proceed to | |
Fault not listed in problem symptoms table |
A | | Fault listed in problem symptoms table |
B |
| B |
| GO TO STEP 8 |
|
A | |
| |
| 7. |
OVERALL ANALYSIS AND TROUBLESHOOTING | (a) Terminals of ECU.
Click here
|
NEXT | |
| |
|
NEXT | |
| |
| NEXT |
| END |
| NEXT |
| GO TO STEP 8 | | 
