Precaution PRECAUTION 1. Before disassembling the transfer assembly, thoroughly clean it by removing any foreign matter. This will help prevent contamination during disassembly and reassembly. 2. When removing the transfer cover or any other light alloy parts, do not pry them off with a screwdriver or other tool that may cause damage. Instead, tap the parts with a plastic-faced hammer. 3. Always arrange removed parts in the order they were removed and protect them from foreign matter. 4. Before installation of each part, thoroughly clean and dry it. Then apply Toyota Genuine Transfer gear oil LF 75W or equivalent to it. Do not use alkaline chemicals to clean aluminum parts, rubber parts or ring gear set bolts. Also, do not use non-residue solvent or other cleaning oils to clean O-rings, oil seals or rubber parts. 5. Coat any sliding surface or rotating parts with Toyota Genuine Transfer gear oil LF 75W or equivalent. 6. Do not directly fix a part in a vise. Place aluminum plates between the part and vise. 7. Replace any damaged or deformed snap rings with new ones. 8. Do not allow the case's mating surface to be scratched. Scratches may lead to oil leakage. 9. Using a razor blade and gasket scraper, remove old seal packing from the seal surface. 10. Clean all parts to remove excess seal packing completely. 11. Clean the sealing surface with solvent so that no residue remains on the seal surface. 12. Apply seal packing in a continuous line of approximately 1.2 mm (0.0472 in.) in diameter along the sealing surface. 13. Be sure to assemble parts within 10 minutes of seal packing application. Otherwise, the seal packing must be removed and reapplied. 14. After sealing parts, do not allow oil to contact the seal for at least 1 hour. 15. Do not allow scratches on a part's contact surface with an oil seal or gasket. Scratches may lead to oil leakage. 16. When press-fitting an oil seal, be careful not to damage the lip of the oil seal and its periphery. Problem Symptoms Table PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary. Transfer system
|
