Toyota Tundra Service Manual: Precaution

PRECAUTION

1. PRECAUTIONS WHEN USING TECHSTREAM

(a) When using the Techstream with the ignition switch OFF to troubleshoot the CAN or LIN communication line:

Connect the Techstream to the vehicle, and turn a courtesy light switch on and off at 1.5 second intervals until communication between the Techstream and vehicle begins.

(b) After all DTCs are cleared, check if the trouble occurs again 6 seconds after the ignition switch is turned ON.

2. IF ANY OF FOLLOWING CONDITIONS ARE MET, KEEP ENGINE IDLING WITH A/C ON (ENGINE SPEED AT LESS THAN 2000 RPM) FOR AT LEAST 1 MINUTE:

  • Refrigerant gas has been refilled or A/C parts have been replaced.
  • A long time has elapsed since the engine was stopped.

NOTICE:

If the engine speed exceeds 2000 rpm, the A/C compressor may be damaged.

3. DO NOT HANDLE REFRIGERANT IN ENCLOSED AREAS OR NEAR OPEN FLAMES

4. ALWAYS WEAR EYE PROTECTION

5. BE CAREFUL NOT TO GET LIQUID REFRIGERANT IN YOUR EYES OR ON YOUR SKIN

If liquid refrigerant gets in your eyes or on your skin:

(a) Wash the area with lots of cold water.

CAUTION:

Do not rub your eyes or skin.

(b) Apply clean petroleum jelly to the skin.

(c) Go immediately to a physician or hospital for professional treatment.

6. NEVER HEAT CONTAINER OR EXPOSE IT TO OPEN FLAME

7. BE CAREFUL NOT TO DROP CONTAINER OR SUBJECT IT TO PHYSICAL SHOCKS

8. DO NOT OPERATE COMPRESSOR WITH INSUFFICIENT REFRIGERANT IN REFRIGERANT SYSTEM

If there is not enough refrigerant in the refrigerant system, oil lubrication will be insufficient and compressor burnout may occur. Necessary care should be taken to avoid this.

9. DO NOT OPEN HIGH PRESSURE MANIFOLD VALVE WHILE COMPRESSOR IS OPERATING

Open and close only the low pressure valve. Opening and closing the high pressure valve could cause the charging cylinder to rupture.

10. BE CAREFUL NOT TO OVERCHARGE SYSTEM WITH REFRIGERANT

If the refrigerant is overcharged, it causes problems such as insufficient cooling, poor fuel economy and engine overheating.

11. DO NOT OPERATE ENGINE AND COMPRESSOR WITHOUT REFRIGERANT

NOTICE:

This may damage the inside of the compressor.

    Parts Location

    Problem Symptoms Table

    See More:

    Toyota Tundra Service Manual > Front Axle Hub: Disassembly
    DISASSEMBLY CAUTION / NOTICE / HINT NOTICE: Do not allow foreign matter, etc. to contact the ABS rotor bearing. PROCEDURE 1. REMOVE FRONT WHEEL ADJUSTING NUT (for 2WD) (a) Using SST and a hammer, release the staked part of the adjusting nut. SST: 09930-00010 (b) Install a nut to the front axle hub, ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2024 Copyright www.ttundra.com
    0.0107