INSPECTION PROCEDURE 1. INSPECT FRONT SEAT OUTER BELT ASSEMBLY 
CAUTION: Do not disassemble the retractor. (a) Before installing the seat belt, check the ELR. (1) When the inclination of the retractor is 15° or less from its installed position, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45° from its installed position, check that the belt locks. If the operation is not as specified, replace the seat belt assembly. (b) for Passenger's Seat only: Check the fastening function of the child restraint system. NOTICE: The check should be performed with the outer belt installed. (1) When the belt is pulled out fully, the belt should automatically start to retract. (2) After the belt has fully retracted, the belt should be able to be pulled out and retracted again. If the operation is not as specified, replace the belt assembly. |
Toyota Tundra Service Manual > Air Conditioning System(for Automatic Air Conditioning System): Pressure Sensor Circuit (B1423/23)
DESCRIPTION This DTC is output when refrigerant pressure is extremely low (196 kPa (2.0 kgf/cm2, 28 psi) or less) or extremely high (3140 kPa (32.0 kgf/cm2, 455 psi) or more). The pressure switch, which is installed on the pipe of the high pressure side to detect refrigerant pressure, outputs a refr ...
