Toyota Tundra Service Manual: Customize Parameters

Toyota Tundra Service Manual / Vehicle Interior / Seat / Front Power Seat Control System(w/ Memory) / Customize Parameters

CUSTOMIZE PARAMETERS

PROCEDURE

1. CUSTOMIZE FRONT POWER SEAT CONTROL SYSTEM

HINT:

The following items can be customized.

NOTICE:

  • When the customer requests a change in a function, first make sure that the function can be customized.
  • Record the current settings before customizing.

(a) Customizing with the Techstream.

(1) Connect the Techstream to the DLC3.

(2) Turn the ignition switch to ON.

(3) Turn the Techstream on.

(4) Enter the following menus: Customize Setting / Seat.

(5) Select the setting by referring to the table below.

Tester Display

Default

Content

Setting

Relevant ECU

Seat Travel Distance

Normal

Allows customizing of the seat movement distance for the power easy access system.

OFF or Short or Normal

Main body ECU (driver side junction block assembly)

(b) Customizing with the Multi-display

HINT:

The following items can be customized.

NOTICE:

  • When the customer requests a change in a function, first make sure that the function can be customized.
  • Record the current settings before customizing.
  • When troubleshooting a function, first make sure that the function is set to the default setting.

(1) Turn the ignition switch to ON.

(2) Enter the following menus: SET UP / Vehicle / Vehicle Customization / Other vehicle settings.

(3) Select the setting by referring to the table below.

Display

Default

Content

Setting

Relevant ECU

Driver's Seat Easy Exit

Full

Allows customization of the seat movement distance for the power easy access system.

Full or Partial or Off

Main body ECU (driver side junction block assembly)
    Short in Sensor with Motor Power Supply Circuit (B2658)

    Data List / Active Test

    See More:

    Toyota Tundra Service Manual > Brake Actuator: Installation
    INSTALLATION CAUTION / NOTICE / HINT NOTICE: In case of replacing the skid control ECU, perform the zero point calibration of the steering angle sensor, master cylinder pressure sensor, and yaw rate and deceleration sensor (See page ). PROCEDURE 1. INSTALL BRAKE ACTUATOR ASSEMBLY (a) Tighten the 3 n ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2025 Copyright www.ttundra.com
    0.0124