Components COMPONENTS ILLUSTRATION 
Installation INSTALLATION CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. HINT:
PROCEDURE 1. INSTALL SEAT HEATER CONTROL SUB-ASSEMBLY LH (a) Attach the clamp to install the seat heater control sub-assembly LH. (b) Connect the connector. 2. INSTALL FRONT SEAT ASSEMBLY (a) for Power Seat: (See page Removal REMOVAL CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. HINT:
PROCEDURE 1. REMOVE FRONT SEAT ASSEMBLY (a) for Power Seat: (See page 2. REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY LH
(b) Detach the clamp to remove the seat heater control sub-assembly LH. |
Toyota Tundra Service Manual > Touch Select 2-4 And High-low System: Automatic Disconnecting Differential Motor Limit Switch Circuit (P17A4)
DESCRIPTION When the A.D.D. actuator is switching between 2WD and 4WD, the DL1 and DL2 terminals of the limit switch are in one of the ON/OFF combinations listed in the table below. Terminal In 2WD Switching between 2WD and 4WD In 4WD DL1 OFF (OPEN) ON (GND) ON (GND) DL2 ON (GND) ON (GND) OFF (OPEN) ...
)
)
