REMOVAL PROCEDURE 1. PRECAUTION CAUTION: Be sure to read Precaution thoroughly before servicing. Click here NOTICE: After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work. Click here 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system. NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Click here 3. REMOVE CENTER LOWER INSTRUMENT COVER Click here 4. REMOVE AIRBAG SENSOR ASSEMBLY (a) Check that the ignition switch is off. (b) Check that the cable is disconnected from the negative (-) battery terminal. CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(d) Remove the 3 bolts and airbag sensor assembly. NOTICE: If the airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the airbag sensor assembly with a new one. |
Toyota Tundra Owners Manual > Using the air conditioning
system: Seat heaters/
seat ventilators
The seat heaters and ventilators heat the seats and maintain good airflow by blowing air from the seats. Seat heaters Turns the seat heater on Hi Mid Lo Off The level indicator lights come on. Press the "" on the button to up and "" to down, and off. Seat ventilators ■ Seat heater Turns the seat ...