Toyota Tundra Service Manual: Installation

INSTALLATION

PROCEDURE

1. INSTALL NO. 2 INSTRUMENT PANEL MOUNTING BRACKET

(a) Install the No. 2 instrument panel mounting bracket with the bolt.

Torque:

10 N·m {102 kgf·cm, 7 ft·lbf}

2. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY

for Column Shift Type:

Click here

for Floor Shift Type:

Click here

3. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

(a) Check that the ignition switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Connect the airbag connector and push in the connector lock. NOTICE: When connecting any airbag connector, take care not to damage the airbag wire harness. *a Connector Lock

(d) Install the lower No. 2 instrument panel airbag assembly with the 3 bolts.

Torque:

10 N·m {102 kgf·cm, 7 ft·lbf}

4. INSTALL LOWER INSTRUMENT PANEL

Click here

5. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Click here

6. INSTALL COWL SIDE TRIM BOARD RH

HINT:

Use the same procedure described for the LH side.

Click here

7. INSTALL FRONT DOOR SCUFF PLATE RH

HINT:

Use the same procedure described for the LH side.

Click here

8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here

9. PERFORM DIAGNOSTIC SYSTEM CHECK

Click here

10. CHECK SRS WARNING LIGHT

Click here