ON-VEHICLE INSPECTION PROCEDURE 1. CHECK FRONT SEAT AIRBAG ASSEMBLY LH (VEHICLE NOT INVOLVED IN COLLISION) (a) Perform a diagnostic system check (see page
(b) With the front seat airbag assembly LH installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the front seat with a new one: Cuts, minute cracks or marked discoloration on the front seatback around the front seat airbag assembly LH. 2. CHECK FRONT SEAT AIRBAG ASSEMBLY LH (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED) (a) Perform a diagnostic system check (see page
(b) With the front seat airbag assembly LH removed from the vehicle, perform a visual check. If there are any defects as mentioned below, replace the front seat airbag assembly LH with a new one:
|
Toyota Tundra Service Manual > Rear View Monitor System(for Radio And Display Type): Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART HINT: If a trouble code is output during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" below. Rear View Monitor System DTC Code Detection Item See page C1622 Open or Short Circuit in Back Camera Signal ...
