Toyota Tundra Service Manual: Removal

REMOVAL

CAUTION / NOTICE / HINT

HINT:

• Use the same procedure for the LH side and RH side.
• The procedure listed below is for the LH side.

PROCEDURE

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here

2. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

(a) for Double Cab:

Click here

(b) for CrewMax:

Click here

3. REMOVE FRONT UPPER ARMREST BASE PANEL LH

Click here

4. REMOVE FRONT LOWER DOOR FRAME BRACKET GARNISH LH

(a) for Double Cab:

Click here

(b) for CrewMax:

Click here

5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

(a) for Double Cab:

Click here

(b) for CrewMax:

Click here

6. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY

(a) for Double Cab:

Click here

(b) for CrewMax:

Click here

7. REMOVE FRONT NO. 1 DOOR TRIM BRACKET

(a) for Double Cab:

Click here

(b) for CrewMax:

Click here

8. REMOVE FRONT DOOR SERVICE HOLE COVER LH

(a) for Double Cab:

Click here

(b) for CrewMax:

Click here

9. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

(a) for Double Cab:

Click here

(b) for CrewMax:

Click here

10. REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

(a) for Double Cab:

Click here

(b) for CrewMax:

Click here

11. REMOVE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

(a) Using a T25 "TORX" driver, remove the 3 screws and the front power window regulator motor assembly LH.

CAUTION:

Do not place your finger, etc. within the range of movement of the window regulator. When removing the power window regulator motor, the force of the spring causes the window regulator to move in the direction of the arrow shown in the illustration (the direction in which the window rises), which may cause injury.

NOTICE:

Be careful when removing the screws as the motor may fall and become damaged.