Toyota Tundra Owners Manual: Driving position memory (driver's seat)

Power easy access system

The driver's seat and steering wheel are automatically adjusted to allow the driver to enter and exit the vehicle easily.

When all of the following have been performed, the driver's seat and steering wheel are automatically adjusted to a position that allows driver to enter and exit the vehicle easily.

• The shift lever has been shifted to P.
• The key has been removed from the engine switch.
• The driver's seat belt has been unfastened.

When any of the following has been performed, the driver's seat and steering wheel automatically return to their original positions.

• The key has been inserted into the engine switch.
• The driver's seat belt has been fastened.

■Operation of the power easy access system When exiting the vehicle, the power easy access system may not operate if the seat is already close to the rearmost position, etc.

■Customization The seat movement amount settings of the power easy access system can be customized.

Driving position memory

Your preferred driving position (the position of the driver's seat, steering wheel and outside rear view mirrors) can be recorded and recalled by pressing a button.

Two different driving positions can be recorded into memory.

■ Recording procedure

1. Check that the shift lever is in P.

2. Turn the engine switch to the "ON" position.

3. Adjust the driver's seat, steering wheel, and outside rear view mirrors to the desired positions.

4. While pressing the "SET" button, or within 3 seconds after the "SET" button is pressed, press button "1" or "2" until the buzzer sounds.

If the selected button has already been preset, the previously recorded position will be overwritten.

■ Recall procedure

1. Check that the shift lever is in P.

2. Turn the engine switch to the "ON" position.

3. Press one of the buttons for the driving position you want to recall until the buzzer sounds.

■To stop the position recall operation part-way through Perform any of the following:

• Press the "SET" button.
• Press button "1" or "2".
• Operate any of the seat adjustment switches (only cancels seat position recall).
• Operate the tilt and telescopic steering control switch (only cancels steering wheel position recall).

■Seat positions that can be memorized The adjusted seat positions can be recorded except for lumbar support positions.

■Operating the driving position memory after the key is removed from the engine switch Recorded seat positions (except the steering wheel position) can be activated up to 30 seconds after the driver's door is opened, even if the key is removed from the engine switch.

■In order to correctly use the driving position memory function If a seat position is already in the furthest possible position and the seat is operated in the same direction, the recorded position may be slightly different when it is recalled.

Memory recall function

A desired driving position can be recalled linked with the unlocking of the door.

■ Registering procedure Record your driving position to button "1" or "2" before performing the following:

1. Turn the engine switch off and close the driver's door.

2. While pressing the button "1" or "2", press on the wireless remote control until the signal beeps.

The driving position is recalled when the driver's door is unlocked using the wireless remote control and the driver's door is opened.

To prevent unintended triggering of the alarm, open and close a door once after a driving position has been recorded. (If a door is not opened within 60 seconds after is pressed, the doors will be locked again and the alarm will automatically be set.) In case that the alarm is triggered, immediately stop the alarm.

■ Cancelation procedure

1. Turn the engine switch off and close the driver's door.

2. While pressing the "SET" button, press on the wireless remote control until you hear 2 beeps.

■If the battery is disconnected The recorded seat positions are erased when the battery is disconnected.