DATA LIST / ACTIVE TEST 1. DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time. (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Navigation System / Data List. (e) According to the display on the Techstream, read the Data List. Navigation System
|
Toyota Tundra Service Manual > 1ur-fe Engine Control: Fuel Pump Relay
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. REMOVE FUEL PUMP RELAY (F/PMP) (a) Remove the fuel pump relay from the engine room relay block. 2. INSPECT FUEL PUMP RELAY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Conditio ...
