REGISTRATION CAUTION / NOTICE / HINT HINT:
PROCEDURE 1. REGISTRATION OF RECOGNITION CODE (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Main Body / Utility / Wireless Code Registration. (e) Select either add or rewrite mode according to the Techstream display. (f) The number of registered codes is indicated. (g) Registration of the door control transmitter assembly (1) If either add mode or rewrite mode has been selected, press the lock and unlock switches on the door control transmitter assembly simultaneously. (2) Within 3 seconds of releasing the lock and unlock switches, press either of the switches on the door control transmitter assembly. NOTICE:
(3) The main body ECU (multiplex network body ECU) automatically performs the power door lock/unlock operation once in order to indicate whether registration has been completed correctly or not. (4) If continuing registration, the next recognition code must be registered in the door control transmitter assembly within 30 seconds. HINT: Up to 6 recognition codes can be registered. (h) Completing the registration mode. (1) Registration mode will end when any of the following occurs:
(i) Perform the following after registration is completed. (1) Perform the wireless door lock control operation check. Click here HINT: If the wireless door lock control does not operate, perform the registration procedure again. |
Toyota Tundra Service Manual > Automatic Transmission System: Dtc Check / Clear
DTC CHECK / CLEAR NOTICE: When the diagnosis system is changed from normal mode to check mode or vice versa, all DTCs and freeze frame data recorded in normal mode are cleared. Before changing modes, always check and make a note of DTCs and freeze frame data. HINT: DTCs which are stored in the ECM c ...